ACID ETCH MARKING
MARKING WITH GROUND
Simply Lay the Tool or Part on the Ground Plate and Touch ETCH-O-MATIC
to it for a Few Brief Seconds and Your Mark is Permanently Etched Into
ETCHING ROUND SURFACES
Drill Bits, Milling Cutters, Tubing, Pipe or nearly anything Round can
be Easily Marked by "Rolling" the Mark on as Shown Above.
DEEP ACID ETCH MARKING
MAKES DEEP ETCH
ETCH-O- MATIC Marks many Metals as Deep as .003" with Deep Etch
Adapter Clip, a Mark that can only be Removed by Grinding a Major Part
of the Surface Away.
If it is Made of Metal
Can Mark It And Even
On It In Just Seconds!
THE METAL ETCHING PROCESS TO ETCH ANYTHING METAL.... IN SECONDS!
ETCHES MARK INTO SURFACE — The ETCH-O-MATIC Metal Etching Process will Etch into the surface
of Anything made of Metal, including Tools, Instruments, Equipment or
Manufactured Parts, anything that can be Typed, Written, Drawn or Photo
Processed on a Special Stencil. This includes Names, Numbers, Designs,
Logos, Trademarks or even Your Own Signature. Using an Electro- Chemical
principle, the New ETCH-O-MATIC can Etch as Deep as .003" of an Inch in
Less than 30 Seconds or Mark the Hardest Tool Steel and Carbides almost
Instantly. It marks any Flat or Round Metal Surface down to 1/16" Diameter
and any Metal Thickness from Thin Foil up to the Largest Castings easily.
Most Marks (which look like Printing or Engraving) take about 3 to 20
Seconds (the Longer Dwell Times are for
Deep Etching) and are Permanently Etched
into the Tool or Manufactured Part.
FAST AND VERY EASY TO USE!
ETCH-O-MATIC is FAST and EASY TO USE. Anyone in Your Organization
can become an EXPERT in JUST MINUTES and produce Professional Looking
In Fact, Etch-O-Matic is by Far the Very Easiest Marking
System to Learn that is
Also, You will find that The ETCH-O-MATIC Metal Etching Process is not only the Fastest way to make
Permanent Marks on Anything Metal, but is by Far the LEAST EXPENSIVE
method on the Market Today. Your Marks will Cost just Fractions of a Cent
to Produce and You will be Extremely Pleased with the Result.
LOOK LIKE LASER MARKS
Most Marks will Compare Favorably with Laser Marking on Metal and are
Easier and Sometimes
Even Faster to Make. In Fact You have Seen Marks made by
Etch-O-Matic hundreds of times before but probably did
Not Realize it since the Marks are Used so often in Commerce Today. If
you have ever seen a Feeler Gauge,
Drill Bit, Milling Cutter, Saw Blade, Knife Blade, Ball Bearing Race,
Carbide Cutter or Thousands of
other types of Metal Tools, Parts, Instruments or Equipment then You have
probably seen Marks made by
Etch-O-Matic. In fact, we have Marks in a good Percentage of all of
the Cars, Trucks, Commercial and Military Aircraft,
Submarines, Hospital Surgical Instruments and Implant Devices and we even
have Marks in the Nose Cone of the Space Shuttle. (Yes, NASA called
and said that they used an
Etch-O-Matic to Mark an Inspection Date and Number in the Nose Cone of the
BASICALLY, ETCH-O-MATIC and the Electro-Chemical Metal Etching
been Proven Over and
Over again during
our 36 Years in Business as the Best Way to Permanently Mark Anything